10mm Radius 30mm x 900mm Breakfast Bar Corner Joint Satin Silver

R-10mm x 28mm-30mm x 900mm Breakfast Bar Corner Joining Strip Satin Silver

This metal breakfast bar corner join trim from Design Hardware features an anodised aluminium satin silver finish that coordinates with many kitchens. This corner trim reduces time and simplifies installation and covers the gap where a postformed worktop meets the end of an perpendicular breakfast bar or any other corner configuration.

Breakfast bar end trims are flat aluminium plates that cover the end of a breakfast bar run, they feature a curved top lip that sits on the top surface of the breakfast bar approximately 2mm high covering any chipped edges within 5mm of the breakfast bar edge. Each end of the trims are profile matched to the breakfast bar so they will fit either a left or right hand installation.

This breakfast bar end trim will suit 28mm - 30mm thick, 900mm wide breakfast bars that feature a 10mm radius to the top and square bottom edge profile. Install using silicone to seal any raw breakfast bar edges to prevent water ingress, and secure the trim in place with countersunk wood screws.

This metal end trim is suited to the following 28mm-30mm breakfast bars:
• Euro profile.
• Waterfall profile.
• Kronospan 28mm waterfall profile.
• Oasis 28mm waterfall profile.
• Odyssey 28mm breakfast bar profile.

This matt silver breakfast bar corner joint is supplied in single units without screws.