R-10 x 40 x 630 mm Worktop Corner Joining Strip Matt Silver
This metal worktop corner join trim from Design Hardware features an anodised aluminium satin silver finish that coordinates with many kitchens. This corner trim reduces time and simplifies installation and covers the gap where a postformed worktop meets the end of an perpendicular worktop or any other corner configuration.
Worktop corner trims are aluminium profiles 20mm wide that feature a profile matched curved designed to sit on the postformed edge of a worktop and a 5mm lip to cover the end of the adjacent worktop in a corner layout arrangement, they will cover any chipped edges within 5mm of the worktop end cut. Each end of the trims are also profile matched to the worktop so they will fit either a left, or right hand installation once the appropriate end is cut down with a hacksaw to the desired length.
This worktop corner joint will suit 38mm - 40mm thick worktops that feature a 10mm radius to the top and bottom long edge profiles. Install using silicone to seal any raw worktop edges to prevent water ingress, and secure the trim in place with countersunk wood screws at the hidden fixing locations. This corner cover trim will suit worktops up to 616mm deep, for deeper worktops our breakfast bar cover trims can be used in the same way.
This metal end trim is suited to the following worktops:
- Artis 10mm radius profile.
- Kronospan 10mm radius profile.
- Oasis 10mm profile.
- Bushboard Odyssey Tekform Gloss profile.
- Bushboard Omega Q10 profile.
This satin silver worktop corner trim is supplied in single units without screws.
Your shopping cart is empty!
